MicroHAM Digi Keyer II Specifications download pdf (Page 8)

For Icom transceivers, install the ICVOX jumper located behind the

PTT IN jack. Otherwise, connect your transceiver PTT Out (linear) to

the PTT IN jack using the appropriate cable.

3. Connect your amplifier PTT (if used) to the PA PTT jack and set the PA

PTT RE/SS jumpers appropriately.

4. Connect your keyer paddles to the PADDLE jack.

5. If you use a foot switch, connect the foot switch to the FOOTSW jack.

6. Plug the DB15M on the radio cable set into the DB15 (RADIO) connector on the rear panel of DIGI

KEYER II and connect each connector from the cable set to the appropriate jacks at the rear panel

of your transceiver. Each connector on the radio interface cable is marked same as the matching

jack on your transceiver.

7. If the radio cable ends with leads for external power, connect these leads to a 12-16V DC power

supply. Be sure to observe the proper polarity.

NOTE: DO NOT use the same power supply as the transceiver.

8. Locate but do not connect the USB cable from DIGI KEYER II to your computer.

NOTE: If you will be installing on a Windows computer, skip to page 9.

Mac OS X INSTALLATION

1. Insert the microHAM CD in your CDROM/DVD drive and navigate to Drivers/OS-X or use your web browser to

go to http://www.ftdichip.com/Drivers/VCP.htm and down load the latest driver image for OS-X.

2. Open FTDIUSBSerialDriver_v2_2_14.dmg by

clicking on it.

3. For OS-X 10.4, 10.5 or 10.6 open

FTDIUSBSerialDriver_10_4_10_5_10_6 and

follow the instructions to install.

4. Plug in the USB cable

5. Turn on the radio or external power supply.

6. Follow the instructions for your software to

configure the application to work with DigiKEYER

II.

NOTE: To access all the capabilities of DigiKEYER II, your OS-X software must be written to use the

microHAM Keyer Protocol or µH Router by Kok Chen, W7AY.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

No comments

MicroHAM Digi Keyer II Specifications Page 8